SAP
Connector Ampact / Grimpi GRIMPI Ø15 – Ø18 mm
Design Features:
The SAP protective cover is designed for covering up splices performed using AMPACT, GRIMPI or similar connectors, on conductors ranging from 15 mm to 18 mm ( fig.1) on distribution lines up to Um 36kV and 52kV, respectively.
With a silicone thickness of 3.5 mm, this device has the required and adequate dielectric strength to ensure satisfactory performance throughout its entire service life.
Installation:
Its clamshell opening design, with 5 locking points by means of pins, (preinstalled on each device), allows easy installation by hand with no tools required to cover up existing splices.
Advantages: The design features to avoid moisture condensation and prevent rainwater ingress include: when properly installed, the flap fitted with 3-4 pins is facing down, allowing the evacuation of any moisture as it is not watertight. In addition, the SAP protective cover incorporates two cone-shaped sections which, by means of silicone tape or UV resistant plastic ties and thanks to the inherent properties of the silicone material, allow OPTIONAL fitting over the conductor cover, performing a two fold function: on the one hand hindering water ingress, and on the other providing an additional fixing for the SWP conductor cover, (Figs. 2 & 3) securing it to prevent it from slipping along the conductor.