SWP-38 & SWP-38/2

PROTECTORS CONDUCTOR COVER 45kV – 66kV HV NETWORKS

References for the models in the set:

An assembly or set has been designed which is made up of the following cover models – SWP-38 and SWP-38/2, and can jointly operate in networks with a maximum operating voltage (Um) of 66kV (*), offering a Phase-Earth protection value on bare conductors of  Um/√3.

Installation:

Once the SWP-38 cover has been cut to the desired length, it is installed on the conductor by hand, requiring no tools, following a simple procedure, thanks to the properties of the silicone material they are made of. The tongue and groove locking design allows a quick, but secure and enduring installation. (Fig.A).

Next, the dielectric enhancer model SWP-38/2 is placed on the closure of the SWP-38 profile. (Fig. B).

The entire set formed by both models is secured using Self-vulcanising tape at one end to fasten the set to the conductor, which is then applied to the set at regulator intervals of ≤40cm in length and at the final end, as indicated in the Instruction Manual.

304.000m installed

2014 - 2020

SWP-38 & SWP-38/2 An assembly or set

envertec_swp38_components

Self-Vulcanizing Tape Included

envertec_tape5

Print or Download Datasheet